Which shaft to use in my ap2

Follow Thread

By Sean M

  • 0 Likes
  • 2 Replies
  1. Sean M

    Sean M
    Brighton, East sussex

    Well an expensive mistake when custom fitting advice is offered may I suggest you listen , had a set of mb 714 irons purchased in feb I play of 5 but these felt a bit flat so purchased a set of ap2 of the the Internet with project pxi 6.0 shaft 1100 pound could not keep down felt like graphite unsuited , so went local golf store and got measured for another set found I needed project x 6.5 another 800 pound so serves me right couldn't wait the ten days for custom build but had I done this first may have saved myself a few quid

  2. Damien J

    Damien J
    North Rocks, NSW

    I was fitted for ap2 in January. Went with the DG s300. Had project x 6.0 in previous cally forged irons. The ball flight is better and slightly higher with the ap2. Very happy.

  3. Chris P

    Chris P
    Katy, TX

    I had Project X 6.0 in my original AP2's and was pleased. I have found with the changes to the COG configuration of the 714's that C-Tapers work better for me. I'm a high ball hitter and the C-Tapers brought my ball flight down and a more boring trajectory. Good Luck on your decision. -Chris

Please login to post a comment.

Sign In

Haven't registered for Team Titleist yet?

Sign Up